ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Vuran Tetaxe
Country: Reunion
Language: English (Spanish)
Genre: History
Published (Last): 18 April 2014
Pages: 304
PDF File Size: 20.57 Mb
ePub File Size: 4.74 Mb
ISBN: 239-3-63861-701-7
Downloads: 2217
Price: Free* [*Free Regsitration Required]
Uploader: Guzil

Before self tune procedure, A. Selectable logic control output. Then press any key to see Pid. Adjustable between 1 and If the temperature unit is changed, the value of the UPL. The normal value is 0.

UnIt Offset value is added to the measurement value. The maximum value is the value of A1. If this parameter is adjusted to a value closer to the energy requirements of the system at the set point, process temperature is prevented to rise or drop to dangerous levels. If this parameter is 1, digital filter runs most quick.

The minimum value is the value of C. Process value during normal operation Mnemonic parameter code during programming SV Display: If this parameter is set to 0, the output power becomes 0 at the set point.

  FERNANDO CHUECA GOITIA PDF

The value of parameter should be increased in interference. It’s a community-based project which helps to repair anything. Therefore, when using a grounding thermocouple, do not connect the logic output terminals to the ground. If no key is pressed within 20 seconds during programming mode, the data is stored automatically and the run mode is entered.

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

Use suitable compensation cables. Make sure that the device is used only for intended purpose. If 0 is selected, soft start feature will be enable and the device reaches set point value quickly. The maximum value is the value of A2. Then the device heats until setpoint value according to PID parameters and calculates the energyrequirement for stable If the parameter is 31, the filter run most slow. The installation and electrical connections must be carried on by a qualified staff and must be according to the relevant locally applicable regulations.

Enter PID parameters of the system if they are known at the begining. Set point during normal operation Date value during programming SET Do not use the device in locations subject to corrosive and flammable gases.

Enda ETC Series PID Temperature Controllers Panel Mount

Adjustable between 1 and seconds. While holding 25 REdY. The maximum of C. SEt is the value of C. If independent or deviation alarm is selected, this parameter can be Lo. Then, the value is adjusted by using If C.

  CSE 646-206 PDF

After 1 second following the release of the key, initial condition is returned. Press any key to deactivate the self-tune procedure. CSET If key is pressed and held 0. Selectable, and Otherwise, Self-Tune should be activated.

Technical Specification |

Then, the value is adjusted by using PV A1. Read this document carefully before using this device. If any key is pressed while P. So the set point can be achieved by minimum fluctuations and in the shortest time. Pay attention to the polarities of the thermocouple cables as shown in the figure right are connected to the. Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: If the selected input type is changed, the value of C.

Technical Specification

All input and output lines that are not connected to the supply network must be laid out as shielded and twisted cables. If band alarm is selected, A1. If self tune is achieved A. The shielding must be grounded on the instrument side. Set appears on the display. It should be