Model © Sears, Roebuck and Co., Hoffman Estates, IL U.S.A. If this CRAFTSMAN Multimeter fails to give complete satisfaction within one year. Owner’s Manual AutoRanging Digital MultiMeter Model No. CAUTION: Read, understand and follow Safety Rules and Operating Instructions in this. Craftsman Digital Mini Multimeter – Voltage Testers – Amazon. com.
|Published (Last):||7 June 2005|
|PDF File Size:||2.91 Mb|
|ePub File Size:||19.27 Mb|
|Price:||Free* [*Free Regsitration Required]|
Put the fuse door back in place. Open the battery door craffsman loosening the screw using a Phillips head screwdriver. Reverse the probe polarity by switching probe position. Read the frequency or duty cycle in the display. To avoid electric shock, disconnect the test leads from any source of voltage before removing the back cover or the battery or fuse doors.
Touch the test probe tips to the circuit or wire you wish to check. The displayed value is the difference between the reference value and the measured value. It is best to disconnect one side of the part under test so the rest of the circuit will not interfere with the resistance reading.
Your browser security needs to be updated
As a result, the reading may show 0 volts when the outlet actually has voltage on 823444. Troubleshooting Electrical Testing Item No. Check to be sure the batteries are properly installed.
Call our Customer Service Line To avoid electric shock, do not operate your meter until the battery door crafgsman in place and fastened securely. On some low AC and DC voltage ranges, with the test leads not connected to a device, the display may show a random, changing reading.
Make sure the probe tips are touching the metal contacts inside the outlet before assuming that no voltage is present. Remove the old fuse from its holder by ctaftsman pulling it out. Touch the test probe tips across the circuit or part under test. A reference voltage, current, etc. Install the new fuse into the holder. Remove old or weak batteries so they do not leak and damage craftwman unit.
Tilt stand and battery access is on the rear of unit. To avoid electric shock, disconnect test leads from any source of voltage before making a temperature measurement.
CRAFTSMAN Calibration – Micro Precision
Positive input jack 6. For maximum safety, the meter and its test leads should not be handled when these terminals are energized.
The display will indicate the proper decimal point, value and symbol AC, V, etc. MAX V This symbol advises the user that the terminal s so marked must not be connected to a circuit point at which the voltage with respect to earth ground exceeds in this case VAC or VDC. Follow all safeguards suggested in this manual. Touch the test leads to the capacitor to be tested. Be sure to observe the correct polarity red lead to positive, black lead to negative.
Craftsman 82344 Manuals
NEVER apply voltage or current to the meter that exceeds the specified maximum: Comments to this Manuals Your Name. Disconnect the test leads from the meter. To print the manual completely, please, download it. Don’t show me this message again. Touch the test probes to the diode under test.
Temperature extremes can shorten the life of the electronic parts and distort or melt plastic parts. Set the function switch to the! The value indicated in the display during the diode check is the forward voltage. Improper use of this device can result in injury or death.
The probe tips may not be long enough to contact the live parts inside some V outlets for appliances because the contacts are recessed deep in the outlets. Set the function switch to position. Be sure that the thermocouple has been removed before changing to any other measurement function.
The display will indicate the proper decimal point and value. Page of 19 Go.
The display will now indicate the difference between the stored value and the measured value. Do not make current measurements on the 10A scale for longer than 30 seconds. The reading will stabilize and give a proper measurement when connected to a circuit.